Redial


To Redial last Dialled Phone from an Extension Number in Centrex EPABX System.


Steps

You Hear

 Dial o + Desired Phone No :

External Busy Tone 

Hang up 

 

Lift handset

Centrex Dial Tone 

Dial 8


Wait, last Phone no

automatically Dialed,


                    Start Talking or try again,

Auto Redial:

    Low Speed Auto Redial


Steps

You Hear

you had dialed Phone No :

External Busy Tone 

 Hang up

 

Lift the hand Set 

Centrex Dial Tone 

Dial 88 

Wait for Confirmation Tone 


                                       Hang up
  • System Will automatically Dial the last Phone number again & again as per programmable interval time and trials (low speech auto redial) until Call gets through,
  • Your Extension must have Auto Redial Feature enabled by programiming mode,


    High Speed Auto Redial


Steps

You Hear

you had Dialed phone No :  

External Busy Tone 

Hang up 

 

Lift the hand set 

Centrex Dial Tone 

Dial 888 

Confirmation Tone 



    When the Extension & Trunk Line will be free System will automatically dial the last phone number again & again with fast frequency as per programmable interval time and trials(high speed auto redial) until the call gets through  


Auto Redial Cancel:

 

Steps

You Hear

Lift the handset from where you 

used Auto Redial facility 

Centrex Dial Tone 

 Dial 80

Confirmation Tone  

Hang up 

 


  • your extension must  have Auto Redial feature by programming mode 
  • check your mode before using this feature. Auto Redial feature is not available in all the Centrex EPABX Systems,


Auto Redial Low / High Programming:

     If the called Telephone number is busy, then  use auto Redial  Automatically after  programmed durations up to 
     programmable Trials. there are two types of Auot Redial Low & High where different values can be  programmed




     Command Dial for Auto Redial Low

Command

Seconds 

 Trial

401 

 003~255

 001~ 255




    Command Dial for Auto Redial High 

Command

Seconds  

 Trial 

402 

003~255 

001~ 255 




Example:
 
   To program Low Auto Redial for 050 Trials with Durations gap of 60 Seconds and High Auto Redial for 070    Trials with Duration gap of 20 Seconds

Steps

You Hear

You are in programming mode

Programming tone

401 + 060 +050 

Confirmation tone

402 + 020 + 070 

Confirmation tone


  • Auto Redial not Available in All Modules, kindly Reconfirm with feature Specified chart
  • Default Setting: Auto redial low 30 second and 20 trials : 
  • Auto redial  high 15 seconds and 30 trials

Comments